Bracelet Sizing Guide
Please refer to the chart and instructions below to find out your bracelet size.
1. Using a bracelet that fits you.
Using a ruler, measure the maximum inside diameter of the bangle in millimetres (mm) and check the nearest inside diameter size (Bangle Size) from Amee Philips bangle sizing table. If between sizes, size up to the nearest bigger number for a slightly looser fit or size down to the nearest smaller number for a slightly closer fit.
2. Measure your wrist.
Wrap a tailors tape measure closely around the wrist you wish to wear the bangle on and read off the circumference of your wrist in mm. If you dont have a tape measure, you can cut a 10mm wide strip of paper, wrap it closely around your wrist and mark where the end meets the strip of paper. Use a ruler to measure the length from the same end to the mark and that equals the circumference of your wrist.
Check the wrist size column in Amee Philips Bangle Sizing Table and read across to the bangle size column. If between sizes, size up to the nearest bigger number for a slightly looser fit or size down to the nearest smaller number for a slightly tighter fit.
